Extron Electronics 3G HD-SDI 101 User Guide - Manual (Page 8)

3G HD-SDI 101 • Installation and Operation
Installation and Operation, cont’d
4
Rack mounting procedures
The unit can be mounted in the front or rear of any of these rack
systems:
RSF 123 3.5" deep 1U VersaTools • ® rack shelf kit
(part #60-190-20)
RSB 123 3.5" deep 1U VersaTools rack shelf (part #60-604-20)
•
RSU 126 6" deep 1U universal rack shelf kit •
(part #60-190-10)
RSB 126 6" deep 1U basic rack shelf (part #60-604-10)
•
RSU 129 9.5" deep 1U universal rack shelf kit •
(part #60-190-01)
RSB 129 9.5" deep 1U basic rack shelf (part #60-604-01)
•
To rack mount the 3G HD-SDI 101, follow these directions:
1.
If necessary, remove rubber feet from the bottom of the unit.
2. Secure the 3G HD-SDI 101 to the shelf with two 4-40 x
3/16" screws in opposite corners of the base (see figure 2-1,
below).
3. Install false faceplate(s) or other unit(s) to the rack shelf.
4. Attach the shelf to the rack with the four provided
10-32 x 3/4" bolts.
EighthRackVersaToolsShelf
(2) 4-40 x 3/16"
Screws
Use 2 mounting holes on
opposite corners.
VersaTools Rack Shelf
1/4 Rack Width Front
False Faceplate
Rack mounting the 3G HD-SDI 101