Xylem AD200-1 VOICE ALARM AUTODIALERS - Manual (Page 9)

Global Water
800-876-1172
• globalw.com
- 9 -
e) Programming Tone/Pulse and PBX
1. Press the “M” key until “PROGRAM: NUMBERS” appears in the LCD,
then press “2”.
2. Press “1” (YES) at the “PROGRAM: T-LINE” prompt.
3. Press “1” (TONE) for touch tone phone service. Press “2” (PULSE) for
pulse (rotary) phone service.
4. After selecting TONE or PULSE, the LCD will display “PROGRAM:
PBX”.
5. Press “1” (ON) to set for PBX phone system, then enter the PBX digit 0-9
(This will allow the unit to dial the PBX digit, wait for a dial tone, then
dial the stored number). Press “2” (OFF) to set for regular phone system
(Waits for a dial tone, then dials the stored number).
f) Programming Exit and Entry Delay
1. Press the “M” key until “PROGRAM: NUMBERS” appears in the LCD,
then press “2” three times.