Xylem AD200-1 VOICE ALARM AUTODIALERS - Manual (Page 8)

Global Water
800-876-1172
• globalw.com
- 8 -
d) To store a pager number and numeric code
1. With the dialer at the “PROGRAM: NUMBERS” prompt, press “1”
(YES).
2. Enter all the digits of the pager number to be dialed. Check the LCD to
insure the correct numbers are pressed.
3. After inputting the entire pager number (1 + area code if needed), press the
PROGRAM/PAUSE (“P”) button and hold it down for about 2 seconds. A
“P” will appear in the LCD and this will pause the dialing sequence for 5
seconds.
4. After the pause, input the numeric code to be delivered. This is the code
that will be displayed on the pager. (Note: Some pager services require a
“#” sign at the end of the numeric message for proper transmission).
5. Press the PROGRAM/PAUSE (“P”) button (momentarily), then the “1”
key. This will store the number and the numeric code in location 1.
6. Repeat step 1, then press all the digits for the second pager number to be
dialed. Check the LCD, input the pause, input the numeric code, then press
the PROGRAM/PAUSE (“P”) button (momentarily) and the “2” key. This
will store the number in location 2.
7. Repeat the process, if needed, for locations 3 and 4.
8. You may store pager number and numeric code in any memory location
(1-4).
9. When testing the pager operation, it is recommended that the AD200-1 be
in the “OPERATE” mode, connected to a phone line and the input
triggered.
NOTE: The pause counts as one digit and is only allowed once in the
dialing sequence.