Xylem CL500 ONLINE CHLORINE ANALYZERS User Manual
Global water, Owner’s manual, Cl500 online residual chlorine monitor
Table of contents
Document Outline
- Measurement Range
- Resolution
- 1.0 Overview
- 2.0 Safety
- 3.0 Theory of Operation
- 4.0 Installation and Commissioning
- 5.0 Operation
- 6.0 Instrument Calibration
- 6.1 Slope (gain) Calibration Procedure
- 6.2 Zero (offset) Calibration Procedure
- 6.3 Restore Factory Settings
- 7.1 Setting the 4-20 mA Output
- 7.2 Configuring the Error Level
- 7.3 Configuring the RS–485 Port
- 7.4 Configuring the Alarms
- 7.5 Enabling the Security Access
- 7.6 Extended Settings
- 7.7 Speed of Response
- 7.8 LCD Backlight Brightness
- 7.9 RS-485 Parameters
- 7.10 Cycle Time
- 7.11 Saving Configuration Settings
- 8.0 Additional Features and Options
- 9.0 Troubleshooting
- 9.1 CL500 Fault Detection
- 9.2 Setting Flow Rate
- 9.3 Clearing Faults
- 9.4 Diagnostic Chart
- Readings are erratic
- (1) Bubbles in solution
- (1) See above
- Readings are lower than expected
- (3) Reagents bad or expired
- (1) Install desiccant cartridge kit
- Upper display flashes
- Sample Over-Range
- Check sample. Sample may be too high to read.
- No current reading displayed
- 9.5 Technical and Customer Assistance
- 10.0 Routine Maintenance
- 11.0 Accessories and Replacement Parts List
- 12.0 Warranty