YSI VisoTurb 700 IQ - Manual (Page 22)

Commissioning VisoTurb
®
700 IQ (SW)
3 - 10 ba76039e01 01/2012
Note
Do not suspend the sensor on the sensor connection cable. Use a
sensor holder or an armature. Information on this and other
IQ S
ENSOR N ET accessories is given in the YSI catalog and on the
Internet.
Connecting the sensor
to the sensor
connection cable
Fig. 3-8 Connect the sensor
Note
The sensor is provided with a long-term stable factory calibration for
turbidity measurement and is immediately ready to carry out
measurements.
1 Take the protective caps off the plug connections of the sensor
and the SACIQ sensor connection cable and keep them safe.
2 Plug the jack of the SACIQ (SW) sensor connection cable onto
the plug head connector of the sensor. At the same time, rotate
the socket so that the pin in the plug head connector (1) clicks
into one of the two holes in the jack.
3 Then, screw the coupling ring (2) of the sensor connection
cable onto the sensor up to the stop.
SACIQ
1
2