YSI DIQ/S 182 XT-4 System 182 XT-4 - Manual (Page 118)

Outputs System 182 XT-4
6 - 26 ba76026e01 01/2012
6.5 Setting tables for current outputs
6.5.1 Functions and settings
To set a current output, its function has to be selected first. Then the
relevant setting table is displayed:
Function of current
outputs and relevant
setting tables
6.5.2 Recorder
Function The measured values of the linked sensor at the current output are set
up as current intensity in the Recorder application. The output of
measured values is laid down in the Recorder type, Start value and End
value settings.
Settings
Function Setting table
No function The current output is not used.
Recorder See section 6.5.2
PID controller See section 6.5.3
Fixed current value See section 6.5.4
Setting Selection/Values Explanation
Recorder type 0 to 20 mA or
4 to 20 mA
Start value Within the
measuring range
(sensor-
dependent) Minimum spacing:
≤ 5 % of the measuring
range
(sensor-dependent)
End value
Measured variable Main variable
Adjoining variable Main variable designates
the actual measured
parameter of the sensor
(e.g. pH, oxygen, etc.).
Adjoining variable
designates an additional
measured parameter
(e.g. temperature).
Attenuation 0 ... 40 mA/s Speed of change of the
output current (mA/s) in
the case of erratic
changes of the input
signal.