Xylem handylab OX 12 - Manual (Page 39)

handylab Ox 12 Operation
39 ba75369e04 01/2011
4.5 Transmitting data
You have the following possibilities of transmitting data:
z One of the following options:
– With the AutoStore function (page 32), measured values are
periodically saved internally (save interval Int 1) and output on the
interface.
– With the Data transmission interval function (Int 2), measured values
are periodically output on the interface (see below).
z With the Output data storage function (page 34), calibration data or saved
measured values are output on the interface.
z Via the analog recorder output (page 40), measured values are output as
voltage values.
z With a communication kit (accessory), data can be transmitted bidirection-
ally (page 41).
Note
If you connect a recorder (analog output), the output on the digital interface
is switched off.
4.5.1 Data transmission interval (Int 2)
The interval to the data transmission (Int 2) determines the chronological in-
terval between automatic data transmissions. After the selected interval ex-
pires, the current data record is transmitted to the interface.
Note
When the AutoStore function is active, the data transmission is performed ac-
cording to the setting of the save interval (Int 1). Set the save interval (Int 1)
to OFF to activate the Data transmission interval (Int 2).
Setting the
Data transmission
interval
The default setting for the interval is OFF.
To start the data transmission, set an interval (5 s, 10 s, 30 s, 1 min,
5 min, 10 min, 15 min, 30 min, 60 min):
1 Press the key and hold it down.
2 Press the key. Int 2 appears on the display.