Xylem handylab OX 12 - Manual (Page 21)

handylab Ox 12 Operation
21 ba75369e04 01/2011
4.2.5 Selecting the measuring range, AutoRange
AutoRange Each of the measuring parameters has 2 measuring ranges available. Au-
toRange causes the measuring instrument to change to measuring range II
if measuring range I is exceeded, and also vice versa.
To switch the automatic measurement range selection on/off, see section
4.6 C
ONFIGURATION . When the AutoRange function is switched on, ARng ap-
pears on the display.
4.2.6 AutoRead AR (drift control)
The AutoRead function (drift control) checks the stability of the measurement
signal. The stability has a considerable effect on the reproducibility of the
measured value.
1 Select the measuring mode with .
2 Activate the AutoRead function with . The current measured
value is frozen (hold function).
3 Start AutoRead with .
The AR display indicator flashes until a stable measured value is
reached.
4 If necessary, start the next AutoRead measurement with TER>.
%
LoBat Cal AR
8
° F
Sal
mbar
S 1
RCL
Auto Store
1/cm
/ K %
TDS UpH Sal
mV/pH
S/ m cm
cm M
Lin
Tref25 Tref20
nLF
AutoCal DIN
AutoCal TEC
Time Baud
Day.Month No.
Ident Year
6 7 1
9 2 7
O
° C
mg/l
ARng
TP
7
RCL
%
LoBat Cal
8
° F
Sal
mbar
S 1
Auto Store
1/cm
/ K %
TDS UpH Sal
mV/pH
S/ m cm
cm M
Lin
Tref25 Tref20
nLF
AutoCal DIN
AutoCal TEC
Time Baud
Day.Month No.
Ident Year
6 7 1
7 0
O
° C
mg/l
TP
ARng AR