Xylem handylab LF 12 - Manual (Page 36)

Operation handylab LF 12
36 ba75367e04 01/2011
4.4.3 Outputting the data storage
You can output the contents of the data storage:
z Stored data on the display
z Calibration data on the display
z Stored data on the serial interface
z Calibration protocol to the interface
Outputting stored
data on the display
You can perform the following activities:
1 Press the key repeatedly until StO dISP appears on the
display.
2 Press the key.
A measured value appears on the display.
The storage location of the data record is displayed for approx.
2 s, then the respective temperature appears.
Display further elements of the data record
(ID number, date, time, storage location) Press
.
Advance one data record (storage location) Press <V>
Go back one data record (storage location) Press <W>
Store Auto
Ident
S 1
LoBat
Tref25
nLF
/ K %
Sal
°
AR
TP
C
M
m
% mg/l
cm
S/ cm
cm 1/
° F
ARng Cal Lin
Tref20
Sal TDS
mbar
O UpH
mV/pH
AutoCal DIN
AutoCal TEC
Time Baud
Day.Month No.
Year
p
S T O
d I s
RCL
Ident
AR
Store
Cal
AutoCal DIN
AutoCal TEC
0
No.
ARng
Sal cm 1/
1
LoBat Lin
Tref20
° F % / K
M
% mg/l
mV/pH
m
Sal TDS
S
Auto
mbar
O UpH
cm
Time Baud
Day.Month
Year
5 3 5
S/ cm
Tref25
nLF
5 2 0
C °
TP
RCL