Fcc regulations – Acer Liquid Glow User Manual
Page 52
52
independent scientific organizations through regular and thorough evaluations of
scientific studies. To guarantee the safety of all persons, regardless of age and
health, the limits include a significant safety buffer.
Before radio devices can be put in circulation, their agreement with European laws
or limits must be confirmed; only then may the CE symbol be applied.
The unit of measurement for the European Council's recommended limit for mobile
telephones is the "Specific Absorption Rate" (SAR). This SAR limit is 2.0 W/kg,
averaged over 10 g of body tissue. It meets the requirements of the International
Commission on Non-Ionizing Radiation Protection (ICNIRP) and was included in the
European Standard EN 50360 for mobile radio devices. The SAR regulation for
mobile telephones is in line with European Standard EN 62209-1. The maximum
SAR value is calculated at the highest output level in all frequency bands of the
mobile telephone.
For body worn operation, this phone (EU model) has been tested and meets the
ICNIRP exposure guidelines, and was included in the European Standard EN 62311
and EN 62209-2 for use with accessories that contain no metal and that position
the handset a minimum of 1.5 cm from the body. Use of other accessories may not
ensure compliance with ICNIRP exposure guidelines. If you do not use a body-worn
accessory and are not holding the phone at the ear, position the handset a
minimum of 1.5 cm from your body when the phone is switched on.
During use, the actual SAR level is usually much lower than the maximum value,
because the mobile telephone works in different output levels. It only transmits with
as much output as is required to reach the network. In general the following applies:
The closer you are to a base station, the lower the transmission output of your
mobile telephone. The tested SAR of this device is as follows:
FCC regulations
This mobile phone complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This mobile phone has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
NCC
CE
Head (W/kg)
Body (W/kg)
Head (W/kg)
1.68
0.863
1.68