Acer PD726 - Manual (Page 51)

9 ... English
Appendices
Replacing the lamp
The projector will detect the lamp life itself. It will show you a
warning message “Lamp is approaching the end of its useful
life in full power operation. Replacement Suggested!” When
you see this message, changing the lamp as soon as possible.
Make sure the projector has been cooled down for at least 30
minutes before changing the lamp.
Warning:
Lamp compartment
is hot! Allow it to cool
down before changing
lamp!
Warning:
To reduce the risk of
personal injury, do not
drop the lamp module
or touch the lamp bulb.
The bulb may shatter
and cause injury if it is
dropped.
Lamp Changing Procedure:
1. Turn the power off the projector by pressing the Power button.
2. Allow the projector to cool down at least 30 minutes.
3. Disconnect the power cord.
4. Remove the cover.

5. Push up and remove the cover. 
6. Remove the 3 screws from the lamp module. 
7. Pull out the lamp module. 
To replace the lamp module, reverse the previous steps.
1
3
4
2