Armasight NSGNYX7P01P3DA1 Nyx7 PRO GEN 3P Night Vision Goggles - Manual (Page 20)

20
3.1.5 MOUNTING ACCESSORY LENSES TO THE NYX-7 PRO
To mount the 3X afocal lens to the device, screw it into the threading of the standard 1X objective lens
on the Nyx-7 PRO.
To mount the 5X or 8X lens, unscrew the existing 1X objective lens of the Nyx-7 PRO and screw in the
5X or 8X lens in its place.
The Nyx-7 PRO configured with an 8X lens can be installed on a tripod. To mount the unit on a tripod,
use the 1/4’’ threaded socket (E) on the housing of the 8X lens.
NOTE:
The unit may be badly damaged if the tripod collapses or overturns. Remove the unit from the
tripod if it is not within your reach.
FIGURE 3-5. MOUNTING ACCESSORY LENSES TO THE NYX-7 PRO
3.1.6 MOUNTING AN IR ILLUMINATOR TO THE NYX-7 PRO
To mount an IR illuminator to the Nyx-7 PRO, use the transfer piece from IR illuminator kit. Perform the
following steps:
1. Install the transfer piece (A) onto the Nyx-7 PRO rail.
2. Tighten the fixing screw (B) on the transfer piece.
3. Loosen the IR illuminator fixing screw (C).
4. Mount the IR illuminator on the rail of transfer piece and tighten the fixing screw (C).
FIGURE 3-6. MOUNTING AN IR ILLUMINATOR TO THE NYX-7 PRO
A
C
B