Armasight NSGNYX7P01P3DA1 Nyx7 PRO GEN 3P Night Vision Goggles - Manual (Page 19)

19
3. Loosen the screw (B). With the button (C) pushed down, insert the Nyx-7 PRO rail into the guide (D) of
the helmet mount bracket. Tighten the screw (B).
4. Put on the helmet with the Nyx-7 PRO attached.
5. Push the button (F) and move the unit along the slide-rail (G) until the most comfortable position is
reached.
6. Loosen the screw (B) and move the unit along the guide (D) for eye relief adjustment.
7. Turn the lever (I) and move the unit along vertical slide-rail until the most comfortable vertical posi-
tion is reached.
8. The helmet mount has a flip-up mechanism. Push the button (E) and lift the unit up until it reaches
the topmost position. The unit will automatically turn off when it reaches this position.
9. Push the same button (E) to lower the Nyx-7 PRO into the correct viewing position. Turn the unit back
on to continue your session.
10. To remove the Nyx-7 PRO from the helmet mount, loosen the screw (B), push down on the button
(C), and slide the unit out of the guide (D).
11. To remove the flip-up mechanism from the helmet mount, loosen the lever (I), pull out the knob (H),
and slide the flip-up mechanism out of the vertical rail.
3.1.4 MOUNTING A TRANSFER ADAPTER TO THE NYX-7 PRO
An optional Transfer Adapter #59 can be used to attach the Nyx-7 PRO to a to PVS7/PVS14 Headset/
Helmet mount. To mount the transfer adapter, unscrew two screws from Nyx-7 PRO rail and detach the
rail. Install the transfer adapter in its place and fix adapter by two screws.
FIGURE 3-4. MOUNTING A TRANSFER ADAPTER TO THE NYX-7 PRO
FIGURE 3-3. MOUNTING THE NYX-7 PRO TO A HELMET
H
I
C
D
B
E
A
F
G