Armasight NAMPVS700133DB1 PVS7 GEN 3 Bravo Night vision goggles - Manual (Page 38)

38
3. If necessary, repeat steps 1 and 2 for the other side of the headband and neck pad.
C. Lacing the Sliding Bar Buckles. While putting on and adjusting the head mount, it is possible for a
strap to slip out of a slide fastener. Perform the following to replace the strap and sliding bar buckle.
1. Thread the strap from the inside of the buckle over the moveable sliding bar (see Figure 4-7). Thread
the strap back through the buckle; this time, thread it under the sliding bar and over the serrated
part of the buckle.
2. Pull the strap through the buckle and tighten as necessary.
3. Repeat steps 1 and 2 for any other straps and buckles that may have come undone.
4.4 SERVICE/PACkING AND UNPACkING
4.4.1 RETURN INSTRUCTIONS
For service, repair or replacements, please email [email protected].
To assist the Service Representative (SR) with determining if the item is repairable, please provide the
following information:
1. Serial Number of the defective item.
2. Thorough description of the malfunction, defect or damage.
3. An explanation of how the malfunction, defect or damage occurred, if known.
If the SR determines that the item is under warranty or should be returned for repair, a Return
Material Authorization number (RMA#) will be provided. RMA can be obtained via e-mail to
[email protected] or via phone by calling Armasight Customer Service at (888)959-2259 Ext. 2 or
via fax (888)959-2260.
When returning the PVS-7 for service or repair, the following procedures should be observed to pre-
vent any additional damage:
1. Verify that the PVS-7 is free of all contaminants, such as dirt or other foreign material.
2. Remove the batteries.
3. Place the cap over the lens.
4. Place the PVS-7 in the hard shipping/ storage case or soft carrying case (if available). If the hard ship-
ping/ storage case is not available, individually package each PVS-7 unit being returned in a suitable
container.
Place the PVS-7 and a copy of the test report or detailed description of the failure in a suitable pack-
ing/ shipping container. Mark the package with the RMA#. Ship the items using the fastest, most easily
traceable, prepaid method to:
Armasight, Inc.
815 Dubuque Avenue
South San Francisco, CA 94080
USA
fIxed
Serrated bar
moveable
SlIdIng bar
FIGURE 4-7. LACING THE SLIDING BAR BUCkLES