beautypg.com

P5g41-m evo chassis intrusion connector, P5g41-m evo analog front panel connector, Chassis – Asus P5G41-M EVO User Manual

Page 26

background image

10. Front panel audio connector (10-1 pin AAFP)

This connector is for a chassis-mounted front panel audio I/O module that supports

either High Definition Audio or AC`97 audio standard. Connect one end of the front

panel audio I/O module cable to this connector.

P5G41-M EVO

P5G41-M EVO Analog front panel connector

AAFP

PIN 1

GN

D

PRESENCE#

SENSE1_RETUR

SENSE2_RETUR

PORT1

L

PORT1

R

PORT2

R

SENSE_SEND

PORT2

L

HD-audio-compliant

pin definition

PIN 1

AGND

NC

NC

NC

MIC

2

MICPWR

Line out_

R

NC

Line out_L

Legacy AC’97

compliant definition

If you want to connect a high-definition front panel audio module to this connector, ensure

that the Front Panel Type item in the BIOS is set to [HD Audio]. If you want to connect an

AC97 front panel audio module to this connector, set the item to [AC97]. See page 2-8 for

details.

11. Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect

one end of the chassis intrusion sensor or switch cable to this connector. The chassis

intrusion sensor or switch sends a high-level signal to this connector when a chassis

component is removed or replaced. The signal is then generated as a chassis intrusion

event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper

cap. Remove the jumper caps only when you intend to use the chassis intrusion

detection feature.

P5G41-M EVO

P5G41-M EVO Chassis intrusion connector

GND

Chassis Signal

+5VSB_MB

CHASSIS

1-16

Chapter 1: Product introduction