Asus PIKE 2208 - Manual (Page 44)

2-30 Chapter 2: RAID configuration
2.2.4 Viewing and Changing Device Properties
This section explains how you can use the WebBIOS CU to view and change the
properties for controllers, virtual drives, and drives.
WebBIOS allows you to view information
for the LSI SAS controller. To view
the properties for the controller, click
Controller Properties on the main
WebBIOS screen. There are three
Controller Properties screens. The right
figure shows the first screen.
The information on this screen is read-
only and cannot be modified directly. Most
of this information is self-explanatory. The
screen lists the number of virtual drives
that are already defined on this controller,
plus the number of drives connected to
the controller.
Click Next to view the second Controller
Properties screen, as shown in the right
figure.
Click Next to view the third Controller
Properties screen, as shown in the
following figure.
The following table describes the entries/options listed on the second and third
Controller Properties screen. We recommend that you leave these options at
their default settings to achieve the best performance, unless you have a specific
reason for changing them.