Asus MEL-B - Manual (Page 13)

ASUS MEL-B User’s Manual 13
III. HARDWARE SETUP
Motherboard Settings
1) KBPWR p. 14 Keyboard Power Up (Enable/Disable)
2) DIP6 p. 15 VIO Setting
3) DIP1,2,3 p. 16 CPU Bus Frequency
4) DIP7,8,9,10 p. 16 CPU Core:Bus Frequency Multiple
Expansion Slots
1) DIMM1,2,3 p. 18 168-Pin DIMM Memory Support
2) Socket 370 p. 19 Central Processing Unit (CPU) Socket
3) SLOT1, SLOT2 p. 20 16-bit ISA Bus Expansion Slots *
4) PCI1,2,3 p. 20 32-bit PCI Bus Expansion Slots
5) AGP p. 21 Accelerated Graphics Port
Connectors
1) KB-PS2KB p. 22 Keyboard Port Connector (6-pin female)
2) FLOPPY p. 22 Floppy Disk Drive Connector (34-1 pins)
3) PARALLEL p. 23 Parallel Port Connector (25-pin female)
4) COM1, COM2 p. 23 Serial Port COM1 and COM2 Connectors (9-pin male)
5) IDE1/IDE2 p. 24 Primary/Secondary IDE Connectors (Two 40-1pins)
6) IDELED p. 24 IDE LED Activity Light (2 pins)
7) CHA_, CPU_, PWR_FAN p. 25 Chassis, CPU, Power Supply Fan Connectors (Three 3-pin)
8) WOL_CON p. 25 Wake-On-LAN Header (3 pins)
9) MSG.LED (PANEL) p. 26 System Message LED (2 pins)
10) SMI (PANEL) p. 26 SMI Switch Lead (2 pins)
11) PWR.SW (PANEL) p. 26 ATX Power & Soft-Off Switch Lead (2 pins)
12) RESET (PANEL) p. 26 Reset Switch Lead (2 pins)
13) PWR.LED (PANEL) p. 26 System Power LED Lead (3-1 pins)
14) KEYLOCK (PANEL) p. 26 Keyboard Lock Switch Lead (2 pins)
15) SPEAKER (PANEL) p. 26 System Warning Speaker Connector (4 pins)
16) USB/MIR P. 27 PS/2 Mouse/USB/IR Combo-Connector (18-1 pins)
17) IR p. 27 IrDA-Compliant Infrared Module Connector (5 pins)
18) ATXPWR p. 28 ATX Power Supply Connector (20 pins)
19) PS/2 p. 28 AT Power Supply Connector (20 pins)
20) SBLINK p. 29 SB-Link TM Connector (6-1 pins)
21) SMB p. 29 SMBus Connector (5-1 pins)
22) WOR p. 30 Wake-On-Ring Header (2 pins)
23) CHASIS p. 30 Chassis Intrusion Sensor Lead (4-1 pins)
* The onboard hardware monitor uses the address 290H-297H so legacy ISA cards
must not use this address; otherwise, conflicts will occur.
Layout Contents III. H/W SETUP