beautypg.com

Iii. hardware setup, 28 asus mel-b user’s manual – Asus MEL-B User Manual

Page 28

background image

28

ASUS MEL-B User’s Manual

III. HARDWARE SETUP

18. ATX Power Supply Connector (20-pin ATXPWR)

This connector connects to an ATX power supply. The plug from the power sup-
ply will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.

IMPORTANT:

Make sure that your ATX power supply can supply at least

10mA on the 5-volt standby lead (+5VSB). You may experience difficulty in
powering on your system if your power supply cannot support the load. For
Wake-On-LAN support, your ATX power supply must supply at least 720mA.

+3.3 Volts (Org\Brn)
-12.0 Volts (Blu)
Ground (Blk)
Power Supply On (Grn)

Ground (Blk)

Ground (Blk)

Ground (Blk)
-5.0 Volts (Wht)
+5.0 Volts (Red)
+5.0 Volts (Red)

Power Good (Org)

+12.0 Volts (Ylw)

+3.3 Volts (Org\Brn)
+3.3 Volts (Org\Brn)

Ground (Blk)

+5.0 Volts (Red)

Ground (Blk)

+5.0 Volts (Red)

Ground (Blk)

+5V Standby (Gry\Vlt)

MEL-B ATX Power Connector

+3.3Volts

-12.0Volts

Ground

Power Supply On

Ground
Ground
Ground

-5.0 Volts

+5.0 Volts
+5.0 Volts

Power Good

+12.0Volts

+3.3 Volts

+3.3 Volts
Ground
+5.0 Volts
Ground
+5.0 Volts
Ground

+5V Standby

19. AT Power Supply Connector (12-pin PS/2)

This connector connects to a standard 5 Volt power supply. To connect the leads
from the power supply, ensure first that the power supply is not plugged. Most
power supplies provide two plugs (P8 and P9), each containing six wires, two of
which are black. Orient the connectors so that the black wires are together.

MEL-B AT Power Connector

Power Plugs from
Power Supply

Power Connector
on Motherboard

P8

P9

ORG
RED
YLW
BLU
BLK
BLK
BLK
BLK
WHT
RED
RED
RED

+5V

PG

+12V

GND

+5V

-12V

-5V

Using a slight angle, align the plastic guide pins on the lead to their receptacles
on the connector. Once aligned, press the lead onto the connector until the lead
locks into place.

Connectors

III. H/W SETUP