Asus P5G41T-M LX2 - Manual (Page 35)

2-10 Chapter 2: BIOS information
The Module Version and USB Devices Enabled items show the auto-detected values. If no
USB device is detected, the item shows None.
USB Functions [Enabled]
Enables or disables the USB functions. Configuration options: [Disabled] [Enabled]
USB 2.0 Controller [Enabled]
Enables or disables USB 2.0 controller. Configuration options: [Enabled] [Disabled]
Legacy USB Support [Auto]
Enables or disables support for Legacy USB storage devices, including USB flash drives and
USB hard drives. Setting this item to [Auto] allows the system to detect the presence of USB
devices at startup. If detected, the USB controller legacy mode is enabled. If no USB device
is detected, the legacy USB support is disabled. Configuration options: [Disabled] [Enabled]
[Auto]
USB 2.0 Controller Mode [HiSpeed]
Allows you to configure the USB 2.0 controller in HiSpeed (480Mbps) or Full Speed
(12Mbps). Configuration options: [FullSpeed] [HiSpeed]
2.4.4 USB Configuration
The items in this menu allows you to change the USB-related features. Select an item then
press to display the configuration options.
USB Mass Storage Device Configuration
USB Mass Storage Reset Delay [20 Sec]
Allows you to set the maximum time that the BIOS waits for the USB storage device to
initialize. Configuration options: [10 Sec] [20 Sec] [30 Sec] [40 Sec]
Emulation Type [Auto]
Allows you to select the emulation type. Configuration options: [Auto] [Floppy]
[Forced FDD] [Hard Disk] [CDROM]
The following items only appear when a USB storage device is plugged in.