Asus P5G41T-M LX2 - Manual (Page 22)

ASUS P5G41T-M LX2 Series 1-13
6. USB connectors (10-1 pin USB56, USB78)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specification that supports up to
480Mbps connection speed.
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
The USB 2.0 module is purchased separately.
P5G41T-M LX2/GB/LPT
P5G41T-M LX2/GB/LPT USB2.0 connectors
PIN 1
USB+5V USB_P6
-
USB_P6
+
GND NC
USB+5V
USB_P5
-
USB_P5
+
GND
USB56
PIN 1
USB+5V USB_P8
-
USB_P8
+
GND NC
USB+5V
USB_P7
-
USB_P7
+
GND
USB78
7. Floppy disk drive connector (34-1 pin FLOPPY)
This connector is for the floppy disk drive (FDD) signal cable. Insert one end of the
cable to this connector, then connect the other end to the signal connector at the back
of the floppy disk drive.
• Pin 5 on the connector is removed to prevent incorrect cable connection when using a
FDD cable with a covered Pin 5.
• The floppy disk drive signal cable is purchased separately.
• The Floppy disk drive connector is an optional item for P5G41T-M LX2 and
P5G41T-M LX2/GB.
P5G41T-M LX2/GB/LPT
P5G41T-M LX2/GB/LPT Floppy disk drive connector
PIN1
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
FLOPPY