Asus P3C2000 - Manual (Page 43)

ASUS P3C2000 User’s Manual 43
3. HARDWARE SETUP
Connectors
3. H/W SETUP
13) IDE Activity LED (2-pin IDE)
This connector supplies power to the cabinet’s IDE activity LED. Read and
write activity by devices connected to the Primary or Secondary IDE connectors
will cause the LED to light up.
P3C2000 IDE Activity LED
TIP: If the case-mounted LED does not
light, try reversing the 2-pin plug.
IDELED
P3C2000
®
3 0
14) Power Supply, CPU, Chassis Fan Connectors
(3-pin PWR_FAN, CPU_, CHA_FAN)
These connectors support cooling fans of 350mA (4.2 Watts) or less. Orientate
the fans so that the heat sink fins allow airflow to go across the onboard heat
sink(s) instead of the expansion slots. Depending on the fan manufacturer, the
wiring and plug may be different. The red wire should be positive, while the
black should be ground. Connect the fan’s plug to the board taking into consid-
eration the polarity of the connector.
NOTE: The “Rotation” signal is to be used only by a specially designed fan with
rotation signal. The Rotations per Minute (RPM) can be monitored using ASUS PC
Probe (see section 6. SOFTWARE REFERENCE) or Intel LDCM Utility.
WARNING! The CPU and/or motherboard will overheat if there is no airflow
across the CPU and onboard heatsinks. Damage may occur to the motherboard
and/or the CPU fan if these pins are incorrectly used. These are not jumpers,
do not place jumper caps over these pins.
P3C2000 12-Volt Cooling Fan Power
CPU_Fan1
PWR_Fan
GND
Rotation
+12V CHA_FAN
GND Rotation +12V
GND
Rotation
+12V
P3C2000
®
3 0