Asus KFN5-D SLI - Manual (Page 53)

ASUS KFN5-D SLI 2-33
12. Front panel audio connector (10-1 pin AAFP1)
This connector is for a chassis-mounted front panel audio I/O module
that supports either HD Audio or legacy AC’97 audio standard.
We recommend that you connect a high-definition front panel audio
module to this connector to avail of the motherboard’s high-definition
audio capability.
13. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor
or switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends
a high-level signal to this connector when a chassis component
is removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. Remove the jumper cap only when you intend to
use the chassis intrusion detection feature.
KFNS-D-SLI
R
KFN5-D SLI Azalia Analog Front Panel Connector
HP_HD
MIC2_L
HP_R HP_L
MIC2_JD
Jack_Sense
MIC2_R
PRESENSE# AGND
AAFP1
KFNS-D-SLI
R
KFN5-D SLI Chassis Intrusion Connector
CHASSIS
+5VSB_MB
Chassis Signal
GND
(Default)
1