Asus P7Q57-M DO - Manual (Page 44)

2-14 Chapter 2: BIOS information
Configure DRAM Timing by SPD [Auto]
Allows you to enable or disable configuring the DRAM Timing by SPD.
Configuration options: [Auto] [Manual]
Initiate Graphic Adapter [PCIE/PCI]
Allows you to decide which graphics controller to use as the primary boot device.
Configuration options: [PCI/PCIE] [PCIE/PCI]
South Bridge Configuration
GbE Controller [Enabled]
Allows you to enable or disable the onboard LAN controller.
Configuration options: [Enabled] [Disabled]
GbE LAN Boot [Disabled]
Allows you to enable or disable the boot ROM in the onboard LAN controller. This
item appears only when the GbE Controller item is set to [Enabled]. Configuration
options: [Disabled] [Enabled]
APIC ACPI SCI IRQ [Disabled]
Allows you to enable or disable APIC ACPI SCI IRQ. Configuration options: [Enabled]
[Disabled]
ME Subsystem Configuration
ASF Support [Enabled]
Allows you to enable or disable the Alert Standard Format (ASF).
Configuration options: [Disabled] [Enabled].
ME HECI Configuration
ME-HECI [Enabled]
When set to [Enabled], Host Embedded Communication Interface (HECI) provides
an interface for the exchange of message between the host software and the ME
firmware. Configuration options: [Disabled] [Enabled].
ME-IDER [Disabled]
Allows you to enable or disable the IDE Redirection interface by which the remote
management console is able to direct the client PC to boot. Configuration options:
[Disabled] [Enabled].
ME-KT [Disabled]
When set to [Enabled], the KT function helps redirect keyboard and POST message
to the remote management console and thus facilitates the control of the client
machine through the network. Configuration options: [Disabled] [Enabled].
BootBlock HECI Message [Disabled]
Allows you to enable or disable the BootBlock HECI message. DO NOT change this
options unless you are an advanced user. Configuration options: [Disabled] [Enabled]
Intel AMT Support [Enabled]
Allows you to enable or diable the Intel ® Active Management Technology.
Configuration options: [Disabled] [Enabled]