Asus P7Q57-M DO - Manual (Page 21)

8. ME Switch. Allows you to enable or disable the Intel ® ME function. Push the switch to
ON/OFF labelled on the I/O Shield to enable/disable this function.
Disable the Intel ® ME function before updating BIOS.
9. USB 2.0 ports 1 and 2. These two 4-pin Universal Serial Bus (USB) ports connect to
USB 2.0/1.1 devices.
10. USB 2.0 ports 3, 4, 5, and 6. These four 4-pin Universal Serial Bus (USB) ports
connect to USB 2.0/1.1 devices.
11. DVI-D port. This port is for any DVI-D compatible device. DVI-D can’t be converted to
output RGB Signal to CRT and isn’t compatible with DVI-I.
12. HDMI port. This is a High-Definition Mulltimedia Interface (HDMI) connector, and is
HDCP compliant allowing playback of HD DVD, Blu-Ray, and other protected content.
13. PS/2 Keyboard port. This port is for a PS/2 keyboard.
1.7.2 Internal connectors
1. USB connectors (10-1 pin USB78, USB910, USB1112, USB1314)
These connectors are for USB 2.0 ports. Connect the USB module cable to any of
these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with the USB 2.0 specification that supports up
to 480Mbps connection speed.
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
The USB 2.0 module is purchased separately.
P7Q57-M DO
P7Q57-M DO USB2.0 connectors
PIN 1
USB+5
V
USB_P10- USB_P10+ GND NC
USB+5
V
USB_P9
-
USB_P9
+
GND
USB910
PIN 1
USB+5
V
USB_P8
-
USB_P8
+
GND NC
USB+5
V
USB_P7
-
USB_P7
+
GND
USB78
PIN 1
USB+5
V
USB_P14- USB_P14+ GND NC
USB+5
V
USB_P13- USB_P13+
GND
USB1314
PIN 1
USB+5
V
USB_P12- USB_P12+ GND NC
USB+5
V
USB_P11- USB_P11+
GND
USB1112
1-11 ASUS P7Q57-M DO