5 system information, 4 ai tweaker menu, System information -9 – Asus P7Q57-M DO User Manual
Page 39: Ai tweaker menu -9, Bios information, Processor, Ai overclock tuner [auto

ASUS P7Q57-M DO
2-9
2.3.5
System Information
This menu gives you an overview of the general system specifications. The BIOS
automatically detects the items in this menu.
Bios Information
Displays the auto-detected BIOS information.
Processor
Displays the auto-detected CPU specification.
System Memory
Displays the auto-detected system memory.
2.4
Ai Tweaker menu
The Ai Tweaker menu items allow you to change the settings for the CPU and other system
devices.
BIOS SETUP UTILITY
Main
Ai Tweaker
Advanced Power Boot Tools Exit
Configure System Performance Settings
Ai Overclock Tuner
[Auto]
CPU Ratio Setting
[Auto]
DRAM Frequency
[Auto]
QPI Frequency
[Auto]
DRAM Timing Control
******* Please key in numbers directly! *******
VCORE Over Voltage
[Offset]
Offset Voltage
[Auto]
IMC Voltage
[Auto]
DRAM Voltage
[16V]
CPU PLL Voltage
[Auto]
PCH Voltage
[Auto]
VAXG Voltage
[Auto]
CPU Spread Spectrum
[Auto]
PCIE Spread Spectrum
[Auto]
v02.61 (C) Copyright 1985-2009, American Megatrends, Inc.
[D.O.C.P.]
It’s designed to
overclock DRAM
frequency by
adjusting BCLK
frequency. [X.M.P.]
When X.M.P. is
enabled BLCK
frequency, CPU
ratio and memory
parameters will be
auto optimized.
Ai Overclock Tuner [Auto]
Allows selection of CPU overclocking options to achieve desired CPU internal frequency.
Select either one of the preset overclocking configuration options:
Manual - Allows you to individually set overclocking parameters.
Auto - Loads the optimal settings for the system.
D.O.C.P. - Overclocks DRAM frequency by adjusting BCLK frequency.
X.M.P. - If you install memory module(s) supporting the eXtreme Memory Profile (X.M.P.)
Technology, choose this item to set the profile(s) supported by your memory
module(s) for optimizing the system performance.
The configuration options for the following sub-items vary depending on the DIMMs you
install on the motherboard.
Select Screen
Select Item
+- Change Field
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit