Asus P5KPL-E - Manual (Page 46)

1-34 Chapter 1: Product introduction
10. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that
supports either HD Audio or legacy AC’97 audio standard.
P5KPL-E Front Panel Audio Connector
P5KPL-E
SENSE2_RETUR
POR
T1L
POR
T1R
POR
T2R
SEBSE_SEND
POR
T2L
SENSE1_RETUR PRESENSE# GND
AAFP
Legacy AC’97
compliant definition
NC
MIC2
Line out_R Line out_L
NC
NC
MICPWR
NC AGND
HD-audio-compliant
pin definition
• We recommend that you connect a high-definition front panel audio
module to this connector to avail of the motherboard’s high-definition audio
capability.
• By default, this connector is set to HD Audio. If you want to connect a High
Definition front panel audio module to this connector, set the Front Panel
Type item in the BIOS to [HD Audio]. If you want to connect an AC’97 front
panel audio module, set this item to [AC97]. See section “2.4.5 Onboard
Devices Configuration” for details.
9. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default , the pin labeled “Chassis Signal” and “ Ground” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
P5KPL-E Intrusion Connector
P5KPL-E
CHASSIS
+5VSB_MB Chassis Signal GN
D
(Default)