Asus P5KPL-E - Manual (Page 67)

ASUS P5KPL-E 2-17
PIO Mode [Auto]
Selects the PIO mode. Configuration options: [Auto] [0] [1] [2] [3] [4]
DMA Mode [Auto]
Selects the DMA mode. Configuration options: [Auto] [SWDMA0] [SWDMA1]
[SWDMA2] [MWDMA0] [MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2]
[UDMA3] [UDMA4] [UDMA5] [UDMA6]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer. Configuration options: [Disabled]
[Enabled]
2.3.5 Storage Configuration
The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Select an item then press if you wish to
configure the item.
IDE Configuration
ATA/IDE Configuration [Enhanced]
Port0 SATA AHCI Speed: GEN 1 (1.5 Gb/sec)
Hard Disk Write Protect [Disabled]
IDE Detect Time Out (Sec) [35]
ATA(PI) 80Pin Cable Detection [Host]
ATA/IDE Configuration [Enhanced]
Allows you to configure ATA/IDE. Configuration options: [Disabled] [Compatible]
[Enhanced]
Legacy IDE Channels [SATA PRI, PATA SEC]
Allows you to select legacy IDE channels. Configuration options: [SATA Only]
[PATA Pri, SATA Sec] [SATA Pri, PATA Sec] [PATA Only]
Hard Disk Write Protect [Disabled]
Allows you to enable or disable the device write protection. This will be effective
only if device is accessed through BIOS.Configuration options: [Disabled]
[Enabled]
Disabled
Compatible
Enhanced
Options
The following item shows only when you set the ATA/IDE Configuration to
Compatible.