Asus TS700-E7/RS8 - Manual (Page 65)

TS700-E7/RS8 4-9
Chapter 4
• DO NOT forget to connect the fan cables to the fan connectors. Insufficient
air flow inside the system may damage the motherboard components.
• These are not jumpers! DO NOT place jumper caps on the fan connectors! These are not jumpers! DO NOT place jumper caps on the fan connectors!
• All fans feature the ASUS Fan Speed Control technology. All fans feature the ASUS Fan Speed Control technology.
6. CPU, front and rear fan connectors
(4-pin CPU_FAN1-2, FRNT_FAN1–4, REAR_FAN1-2)
The fan connectors support cooling fans. Connect the fan cables to the fan
connectors on the motherboard, ensuring that the black wire of each cable
matches the ground pin of the connector.
5. SAS connector -- PSAS connectors
SAS connector - PSAS connectors are for the SAS signal cables for SAS
hard disk drives that allows up to 6Gb/s of data transfer rate.
If you installed SAS hard disk drives, you can create a RAID 0, RAID 1, RAID
10, or RAID 5 configuration.
The actual data transfer rate depends on the speed of SAS hard disks installed.