2 chassis footpads, 3 redundant power supply module, Chassis footpads -29 – Asus TS700-E7/RS8 User Manual
Page 49: Redundant power supply module -29, Chapter 2
TS700-E7/RS8
2-29
Chapter 2
2.9.2
Chassis footpads
The barebone server system is shipped with four footpads attached to the bottom
of the chassis for stability. You need to remove these footpads if you wish to install
the system to a rack (Refer to Chapter 3: Installation options of this user guide, and
to the “Rackmount Kit” user guide for instructions)
To remove the footpads:
1. Lay the system chassis on its side.
2. Remove the footpad by rotating
it counterclockwise with a Philips
(cross) screwdriver.
3. Repeat step 1 and 2 to remove the
other three footpads.
2.9.3
Redundant power supply module
The system is compatible with the 620W (for Taiwan only) and 800W redundant
power supply module.
You MUST disconnect all power cable plugs from the motherboard and other
installed devices before removing the power supply unit.
To install the redundant power supply module:
1. Remove the redundant power
supply dummy cover.
620W redundant power supply (forTaiwan only)
800W redundant power supply