Asus TS700-E7/RS8 - Manual (Page 148)

6-28 Chapter 6: RAID configuration
Chapter 6
8. Press to create the recovery set and return to the main menu, or to
go back to the CREATE VOLUME menu.
If a recovery set is created, you cannot add more RAID sets even when you
have more non-RAID disks installed in your system.
5. Use the up/down arrow keys to select a drive, press to select a
Master disk, and then press to select a Recovery disk. A small
triangle marks the selected drive. Press after completing your
selection.
6. When the Sync item is selected, use the up/down arrow keys to select a sync
option that you want and press .
7. When the Create Volume item is selected, press . The following
warning message appears.
WARNING: ALL DATA ON SELECTED DISKS WILL BE LOST.
Are you sure you want to create this volume? (Y/N):
2. Enter a name for the recovery set and press .
3. When the RAID Level item is selected, press the up/down arrow keys to
select Recovery, and then press .
4. When the Disks item is selected, press to select the hard disk drives
you want to include in the recovery set. The SELECT DISKS screen appears.
[ SELECT DISKS ]
Port Drive Model Serial # Size Status
0 ST3300656SS HWAS0000991753TR 279.3GB Non-RAID Disk
1 ST3300656SS 37VN00009846RAJ1 279.3GB Non-RAID Disk
2 ST3300656SS 397600009846UEDY 279.3GB Non-RAID Disk
3 ST3300656SS GWC50000991756G6 279.3GB Non-RAID Disk
Select 1 Master and 1 Recovery disk to create volume.
[[↑↓]-Prev/Next [TAB]-(M)aster [SPACE]-(R)ecovery [ENTER]-Done