Asus M2N 1394 - Manual (Page 63)

ASUS MN 1394 -3
Memclock Mode [Auto]
[Auto] allows the BIOS to set the memclock mode automatically.
[Limit] allows you to select from any of the standard values.
[Manual] allows the BIOS to set the memclock mode manually.
Configuration options: [Auto] [Limit] [Manual]
The following item appears when the Memclock Mode item is set to [Limit].
Memclock Value [400 MHz]
Allows you to set the memclock value.
Configuration options: [400 MHz] [533 MHz] [667 MHz] [800 MHz]
MCT Timing Mode [Auto]
[Auto] allows the BIOS to set the MCT timing mode automatically.
[Manual] allows you to set the values by yourself.
Configuration options: [Auto] [Manual]
The following items appear when the MCT Timing Mode item is set to [Manual].
CAS Latency (CL) [Auto]
Configuration options: [Auto] [3.0] [4.0] [5.0] [6.0]
TRAS [Auto]
Configuration options: [Auto] [5 CLK] [6 CLK]... [18 CLK]
TRP [Auto]
Configuration options: [Auto] [3 CLK] [4 CLK]... [6 CLK]
TRCD [Auto]
Configuration options: [Auto] [3 CLK] [4 CLK]... [6 CLK]
TRRD [Auto]
Configuration options: [Auto] [2T] [3T] [4T] [5T]
TRC [Auto]
Configuration options: [Auto] [11T] [12T] [13T]... [25T]
Bank Interleaving [Auto]
Sets whether to allow memory accesses to be spread out over BANKS on the
same node or across nodes, decreasing access contention.
Configuration options: [Disabled] [Auto]
Enable Clock to All DIMMs [Disabled]
Allows you to enable unused clocks to DIMMs even memory slots are not
populated.
Configuration options: [Disabled] [Enabled]
MemClk Tristate C3/ATLVID [Disabled]
Allows you to enable or disable Memclk Tri-Stating during C3 and Alt VID.
Configuration options: [Disabled] [Enabled]
MemClk Tristate C3/ATLVID [Enabled]
Allows you to enable or disable memory remapping around memory hole.
Configuration options: [Disabled] [Enabled]