Asus M2N 1394 - Manual (Page 55)

ASUS MN 1394 -15
2.3.4 IDE Configuration
The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Select an item then press if you wish to
configure the item.
IDE Configuration
Onboard IDE Controller [Enabled]
OnChip S-ATA Controller [Enabled]
SATA Mode Select [IDE Mode]
Onboard IDE Controller [Enabled]
Allows you to enable or disable the onboard IDE controller.
Configuration options: [Enabled] [Disabled]
OnChip S-ATA Controller [Enabled]
Allows you to enable or disable the OnChip SATA.
Configuration options: [Disabled] [Enabled]
SATA Mode Select [IDE Mode]
Configuration options: [IDE Mode] [RAID Mode] [AHCI Mode]
2.3.5 Primary IDE Master/Slave
While entering Setup, the BIOS automatically detects the presence of IDE devices.
There is a separate sub-menu for each IDE device. Select a device item then
press to display the IDE device information.
Third IDE Master
Device : Not Detected
Type
[Auto]
LBA/Large Mode [Auto]
Block(Multi-sector Transfer) M [Auto]
PIO Mode [Auto]
DMA Mode [Auto]
SMART Monitoring [Auto]
32Bit Data Transfer [Enabled]