Asus MES-VM - Manual (Page 47)

ASUS MES-VM User’s Manual 47
4. BIOS SETUP
4. BIOS SETUP
Onboard FDC Controller [Enabled]
When [Enabled], this field allows you to connect your floppy disk drives to
the onboard floppy disk drive connector instead of a separate controller card.
If you want to use a different controller card to connect the floppy disk drives,
set this field to [Disabled]. Configuration options: [Disabled] [Enabled]
Onboard Serial Port 1 [3F8H/IRQ4]
This allows you to set the address for the onboard serial connector. Serial
Port 1 and Serial Port 2 must have different addresses. Configuration op-
tions: [3F8H/IRQ4] [2F8H/IRQ3] [3E8H/IRQ4] [2E8H/IRQ10] [Disabled]
Onboard Serial Port 2 [2F8H/IRQ3]
This allows you to set the address for the onboard serial connector. Serial
Port 1 and Serial Port 2 must have different addresses. Configuration op-
tions: [3E8H/IRQ4] [2E8H/IRQ10] [Disabled] [3F8H/IRQ4] [2F8H/IRQ3]
UART2 Use Infrared [Disabled]
When enabled, this field activates the onboard infrared feature and sets the
second serial UART to support the infrared module connector on the moth-
erboard. If your system already has a second serial port connected to the
onboard COM2 connector, it will no longer work if you enable the infrared
feature. By default, this field is set to [Disabled], which leaves the second
serial port UART to support the COM2 serial port connector. See IrDA-
Compliant Infrared Module Connector in 3.8 External Connectors. Con-
figuration options: [Disable] [Enabled]
4.4.2 I/O Device Configuration
I/O Device Config