Asus P/I-AP6N - Manual (Page 30)

30 ASUS P/I-AP6N User’s Manual
III. INSTALLATION
(Connectors)
III. INST
ALLA
TION
18. Power Input Connector (12-pin block)
This connector connects to a standard 5 Volt power supply. To connect the leads
from the power supply, ensure first that the power supply is not plugged. Most
power supplies provide two plugs (P8 and P9), each containing six wires, two of
which are black. Orient the connectors so that the black wires are together.
AT Power Connector
on Motherboard Power Plugs from
Power Supply
-12V
-5V
+12V
+5V
PG
GND
+5V
P9
P8
ORG
RED
YLW
BLU
BLK
BLK
BLK
BLK
WHT
RED
RED
RED
R
Using a slight angle, align the plastic guide pins on the lead to their receptacles
on the connector. Once aligned, press the lead onto the connector until the lead
locks into place.
AT Power Connector with ATX Power Supply (3-pin JP2)
For ATX Power Switch, Soft Power Switch, and remote power on functions, an
ATX power supply and an ATX to AT power connector adapter are required.
The ATX to AT power connector adapter will allow an ATX power supply to be
used on this AT motherboard with additional ATX signals connected to this lead.
The ATX power switch button will be connected to JP3.
For ATX soft power features
on this AT motherboard, you
need an ATX power supply,
optional ATX to AT power
connector adapter, and a
momentary switch button.
ATX Power Switch Lead
To ATX Power Supply
Optional ATX to AT Power
Connector Adapter
To AT Power Connector To PWRATX
R
+5V Standby (Vlt)
Power On (Grn)
Ground (Blk)
JP2 JP3
ATX Power Switch (2-pin JP3)
The system power can be controlled by a momentary switch connected to JP3.
Pushing the button once (push slowly) will switch the system between ON and
OFF. The system power LED shows the status of the system's power.