Asus P/I-AP6N - Manual (Page 20)

20 ASUS P/I-AP6N User’s Manual
III. INSTALLATION
VGA Memory Upgrade
The ASUS P/I-AP6N motherboard comes with 2MB DRAM for the onboard VGA.
Four sockets are available to upgrade the VGA memory to 4MB by adding four
512KB DRAM chips. 3MB is not supported on this product. Specifications may
change without notice.
Onboard VGA DRAM Specification:
40 pins SOJ, 256Kx16, DUAL CAS EDO DRAM 40ns
Suggested VGA DRAM for P/I-AP6N:
1. TM T224162A-40JE
2. EtronTech Em614163A-40
Small indentation on the chip's sloped edge
Socket's cut corner
This is an example of an installed DRAM. The indentation is made white for vis-
ibility, it is normally black.
1. Match the small indentation on the chip’s sloped edge with the socket’s cut corner.
2. Place the chip flat and evenly into the socket and press firmly but carefully so that
the chip enters evenly. When installed, the chip should be flush with the socket.
WARNING: Installing the memory chip incorrectly may damage the memory
and the product itself.
IMPORTANT: Make sure that all VGA memory are of the same type and speed to
ensure reliable operation.
III. INST
ALLA
TION
(System Memory)