Asus P5QL SE - Manual (Page 30)

1-20 Chapter 1: Product introduction
1.10.2. Internal.connectors
1.. Floppy.disk.drive.connector.(34-1.pin.FLOPPY)
This connector is for a floppy disk drive (FDD) signal cable. Connect one end of an
FDD cable to this connector and the other end to the signal connector at the back of a
floppy disk drive.
• Pin 5 on the connector is removed to prevent incorrect cable connection when using a
FDD cable with a covered Pin 5.
• The FDD cable is purchased separately.
P5QL SE
FLOPPY
NOTE:Orient the red markings
on the floppy ribbon cable to PIN 1.
PIN1
P5QL SE Floppy disk drive connector
2.. Digital.audio.connector.(4-1.pin.SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port. Connect
an S/PDIF Out module cable to this connector, then install the module to a slot opening
at the back of the system chassis.
P5QL SE Digital audio connector
P5QL SE
SPDIF_OUT
+5
V
SPDIFOUT GND
The S/PDIF module is purchased separately.