Asus CUEP2-M - Manual (Page 69)

ASUS CUEP2-M User’s Manual 69
4. BIOS SETUP
4. BIOS SETUP
Power Menu
Video Off Option [Suspend -> Off ]
This field determines when to activate the video off feature for monitor
power management. Configuration options: [Always On] [Suspend -> Off]
Video Off Method [DPMS OFF]
This field defines the video off features. The DPMS (Display Power Manage-
ment System) feature allows the BIOS to control the video display card if it
supports the DPMS feature. [Blank Screen] only blanks the screen (use this
for monitors without power management or “green” features. If set up in your
system, your screen saver will not display with [Blank Screen] selected). [V/
H SYNC+Blank] blanks the screen and turns off vertical and horizontal scan-
ning. Configuration options: [Blank Screen] [V/H SYNC+Blank] [DPMS
Standby] [DPMS Suspend] [DPMS OFF] [DPMS Reduce ON]
HDD Power Down [Disabled]
This feature shuts down any IDE hard disk drives in the system after a
period of inactivity as set in this user-configurable field. This feature does
not affect SCSI hard drives. Configuration options: [Disabled] [1 Min] [2
Min] [3 Min]...[15 Min]
Suspend-to-RAM Capability [Disabled]
Suspend-to-RAM (STR) is an energy-saving feature. In Suspend-to-RAM
state, all devices on the computer are turned off, except for the system RAM.
Thus, the PC consumes less than 5 Watts of power. Select [Enabled] if your
power supply can supply at least 720mA on the +5VSB lead to support the
STR function. If the expansion cards you use on the motherboard do not
support the STR function, you must leave this field on the default setting
[Disabled]. NOTE: This field is only effective for Windows 98. Configura-
tion options: [Disabled] [Enabled]
Suspend Mode [Disabled]
Sets the time period before the system goes into suspend mode. NOTE:
This field is effective for DOS, Windows 9x, and Windows NT 4.0 environ-
ments. Configuration options: [Disabled] [1~2 Min] [2~3 Min]...[1 Hour]
PWR Button < 4 Secs [Soft Off]
When set to [Soft off], the ATX switch can be used as a normal system
power-off button when pressed for less than 4 seconds. [Suspend] allows
the button to have a dual function where pressing less than 4 seconds will
place the system in sleep mode. Regardless of the setting, holding the ATX
switch for more than 4 seconds will power off the system. Configuration
options: [Soft off] [Suspend]