Asus P4G800-V - Manual (Page 32)

1-22 Chapter 1: Product introduction
8. System panel connector (10-1 pin HPANEL1)
This connector accommodates several system front panel functions.
P4G800-V
P4G800-V Front Panel Audio Connector
HPANEL1
PLED- PWR PLED+
Ground
GND
Reset
HDLED+ HDLED-
Power LED
Reset SW
ATX Power
Switch*
HDLED
• System Power LED Lead (2-1 pin PWR LED)
This 2-1 pin connector connects to the system power LED. The LED lights up
when you turn on the system power, and blinks when the system is in sleep
mode.
• Hard disk activity LED (2-pin HD LED)
This 2-pin connector supplies power to the hard disk activity LED. The read
and write activities of any device connected to the primary or secondary IDE
connector cause this LED to light up.
• ATX Power Switch / Soft-Off Switch Lead (2-pin PWR BTN)
This connector connects a switch that controls the system power. Pressing the
power switch turns the system between ON and SLEEP, or ON and SOFT
OFF, depending on the BIOS or OS settings. Pressing the power switch while
in the ON mode for more than 4 seconds turns the system OFF.
• Reset Switch Lead (2-pin RESET)
This 2-pin connector connects to the case-mounted reset switch for rebooting
the system without turning off the system power.