Asus P4G800-V - Manual (Page 28)

1-18 Chapter 1: Product introduction
1.12 Connectors
This section describes and illustrates the internal connectors on the motherboard.
1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the floppy
drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables
with pin 5 plug).
2. Serial ATA connectors (7-pin P31, P30)
These next generation connectors support the thin Serial ATA cables for Serial ATA
hard disks. The current Serial ATA interface allows up to 150 MB/s data transfer
rate, faster than the standard parallel ATA with 133 MB/s (Ultra ATA/133).
P4G800-V
NOTE: Orient the red markings on
the floppy ribbon cable to
PIN 1
P4G800-V Floppy Disk Drive Connector
PIN 1
FLOPPY
P4G800-V
P4G800-V SATA Connectors
P30
GND RSA
T
A_TXP2
RSA
T
A_TXN2
GND RSA
T
A
_RXP2
RSA
T
A
_RXN2
GND
P31
GND
RSA
T A_TXP2
RSA
T
A
_TXN2
GND
RSA
T A
_RXN2
RSA
T A
_RXP2
GND