Asus M2N-VM DVI - Manual (Page 82)

2-36 Chapter 2: BIOS setup
2.5.4 APM Configuration
APM Configuration
Power Button Mode [On/Off]
Restore on AC Power Loss [Power Off]
Power On By PCI Device [Disabled]
Power On By Ring [Disabled]
Power On By PS/2 KB/MS [Disabled]
Power On By RTC Alarm [Disabled]
Power.Button.Mode.[On/Off]
Allows the system to go into On/Off mode or suspend mode when the power
button is pressed.
Configuration options: [On/Off] [Suspend]
Restore.on.AC.Power.Loss.[Power.Off]
When set to Power Off, the system goes into off state after an AC power loss.
When set to Power On, the system goes on after an AC power loss.
Configuration options: [Power Off] [Power On]
Power.On.By.PCI.Devices.[Disabled]
When set to [Enabled], this parameter allows you to turn on the system through a
PCI LAN or modem card. This feature requires an ATX power supply that provides
at least 1A on the +5VSB lead.
Configuration options: [Disabled] [Enabled]
Power.On.By.Ring.[Disabled]
Enable or disable RI to generate a wake event.
Configuration options: [Disabled] [Enabled]
Power.On.By.PS/2.KB/MS.[Disabled]
Enable or disable PS/2 Keyboard/Mouse to generate a wake event. Configuration
options: [Disabled] [Enabled]
Power.On.By.RTC.Alarm.[Disabled]
Allows you to enable or disable RTC to generate a wake event. When this item is
set to Enabled, the items RTC Alarm Date, RTC Alarm Hour, RTC Alarm Minute,
and RTC Alarm Second appear with set values.
Configuration options: [Disabled] [Enabled]
Go into On/Off
or Suspend when
Power button is
pressed.