Asus M2N-VM DVI - Manual (Page 62)

2-16 Chapter 2: BIOS setup
2.3.4. IDE Configuration
The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Select an item then press if you wish to
configure the item.
IDE Configuration
Onboard IDE Controller [Enabled]
Serial-ATA Devices [Enabled]
SATA Mode select [SATA Mode]
Onboard.IDE.Controller.[Enabled]
Allows you to enable or disable the onboard IDE controller.
Configuration options: [Enabled] [Disabled]
Serial-ATA.Devices.[Enabled]
Allows you to disable or set the Serial-ATA devices.
Configuration options: [Enabled] [Disabled]
SATA.Mode.select.[SATA.Mode]
Allows you to . select the SATA Mode.
Configuration options: [SATA Mode] [RAID Mode]
The following items appears only when the SATA Mode select item is set to
[RAID Mode].
SATA.Primary.Master/Slave.Channel.[Disabled]
Allows you to disable or enable the Serial-ATA Primary Master/Slave Channel.
Configuration options: [Enabled] [Disabled]
SATA.Secondary.Master/Slave.Channel.[Disabled]
Allows you to disable or enable the Serial-ATA Secondary Master/Slave Channel.
Configuration options: [Enabled] [Disabled]