Asus M2N-VM DVI User Manual

Page 40

1-28

Chapter 1: Product introduction

5.. CPU,.Chassis,.and.Power.Fan.connectors.

(4-pin.CPU_FAN,.3-pin.CHA_FAN1)
The fan connectors support cooling fans of 350mA~740mA (8.88W max.) or

a total of 1A~2.22A (26.64W max.) at +12V. Connect the fan cables to the fan

connectors on the motherboard, making sure that the black wire of each cable

matches the ground pin of the connector.

Do not forget to connect the fan cables to the fan connectors. Insufficient air

flow inside the system may damage the motherboard components. These are

not jumpers! DO NOT place jumper caps on the fan connectors.

6.. Digital.audio.connector.(4-1.pin.SPDIF_OUT)

This connector is for an additional Sony/Philips Digital Interface (S/PDIF)

port(s). Connect the S/PDIF module cable to this connector, then install the

module to a slot opening at the back of the system chassis.

Only CPU Fan supports Q-Fan.

The S/PDIF module is purchased separately.

M2N-VM DVI