Asus TS500-E2 - Manual (Page 46)

C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p 2 - 2 6 2 - 2 6 2 - 2 6 2 - 2 6 2 - 2 6
2.9.2 2.9.2 2.9.2 2.9.2 2.9.2 SCSI backplane connections SCSI backplane connections SCSI backplane connections SCSI backplane connections SCSI backplane connections
(in RS8 and RS4 models only)
(in RS8 and RS4 models only) (in RS8 and RS4 models only) (in RS8 and RS4 models only) (in RS8 and RS4 models only)
Two SCSI backplanes come pre-installed in the TS500-E2 RS8 model. One
SCSI backplane comes pre-installed in the RS4 model. The SCSI backplane has
four 68-pin SCSI connectors to support SCA SCSI hard disks. The backplane
design incorporates a hot swap feature to allow easy connection or removal
of SCSI hard disks. The LEDs on the backplane connect to the front panel
LEDs to indicate HDD access, HDD failure, thermal failure, or fan failure. See
section “1.6 LED information.”
Front side Front side Front side Front side Front side
The front side of the SCSI backplane faces the front panel when installed.
This side includes four SCSI connectors for the hot swap drive trays.
H D D s t a t u s L E D s H D D s t a t u s L E D s H D D s t a t u s L E D s H D D s t a t u s L E D s H D D s t a t u s L E D s
H D D a c t i v i t y L E D s H D D a c t i v i t y L E D s H D D a c t i v i t y L E D s H D D a c t i v i t y L E D s H D D a c t i v i t y L E D s
D i s k d r i v e 1 D i s k d r i v e 1 D i s k d r i v e 1 D i s k d r i v e 1 D i s k d r i v e 1
D i s k d r i v e 2 D i s k d r i v e 2 D i s k d r i v e 2 D i s k d r i v e 2 D i s k d r i v e 2
D i s k d r i v e 3 D i s k d r i v e 3 D i s k d r i v e 3 D i s k d r i v e 3 D i s k d r i v e 3
D i s k d r i v e 4 D i s k d r i v e 4 D i s k d r i v e 4 D i s k d r i v e 4 D i s k d r i v e 4