Asus TS500-E2 - Manual (Page 36)

C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p C h a p t e r 2 : H a r d w a r e s e t u p 2 - 1 6 2 - 1 6 2 - 1 6 2 - 1 6 2 - 1 6
3. When released, pull up the drive bay lock bar. Underneath the lock bar
are two pegs that match the holes on the drive bay. This mechanism
secures the drive to the bay in place of screws.
4. While holding up the drive lock bar,
carefully insert a 5.25-inch drive
into the bay, until the back of the
drive aligns to the rear edge of the
drive cage.
5. Connect the IDE cable to the IDE
connector on the back of the
drive.
6. Connect a 4-pin plug from the
power supply to the power
connector on the back of the
drive.
Due to space constraints inside the chassis, do not insert the drive all the
way at this time. This will allow you enough space to easily connect the
drive cables.
I D E c a b l e I D E c a b l e I D E c a b l e I D E c a b l e I D E c a b l e
P o w e r p l u g P o w e r p l u g P o w e r p l u g P o w e r p l u g P o w e r p l u g
D r i v e b a y h o l e s D r i v e b a y h o l e s D r i v e b a y h o l e s D r i v e b a y h o l e s D r i v e b a y h o l e s
L o c k p e g s L o c k p e g s L o c k p e g s L o c k p e g s L o c k p e g s