Asus RS120-E5/S - Manual (Page 110)

6-10 Chapter 6: RAID configuration
Using New Configuration
When a RAID set is already existing, using the New Configuration command
erases the existing RAID configuration data. If you do not want to delete the
existing RAID set, use the View/Add Configuration command to view or create
another RAID configuration.
To create a RAID set using the New Configuration option:
1. From the utility main menu, highlight Configure, then press .
2. Use the arrow keys to select New Configuration, then press .
3. Follow steps 3 to 7 of the previous section.
4. Select
Size from the Logical Drive menu, then press .
5. Key-in the desired logical drive size, then press .
6. Follow steps 8 to 13 of the previous section to create the RAID set.
LSI Logic Software RAID Configuration Utility Ver A.51 Aug 13, 2007
Use Cursor Keys to Navigate Between Items And Press Enter To Select An Option
Management Menu
Configure
Initialize
Objects
Rebuild
Check Consistency
Clear Existing Configuration And Start A New Configuration
Configuration Menu
Easy Configuration
New Configuration
View/Add Configuration
Clear Configuration
Select Boot Drive
LSI Logic Software RAID Configuration Utility Ver A.51 Aug 13, 2007
Use Cursor Keys To Navigate Between Items And Press Enter To Select An Option
Management Menu
Configure
Initialize
Objects
Rebuild
Check Consistency
DNLIN A00-00
DNLIN A00-01
0
1
Easy Configuration - ARRAY SELECTION
Logical Drive(s) Configured
LD RAID Size #Stripes StripSz Status
0 1 77247MB 2 64 KB ONLINE
Logical
RAID = 1
Size = 77247MB
DWC = Off
RA = On
Accept
SPAN = NO
Enter VD Size (MB):
Enter VD Size (MB): 77247