Asus ASMB3-iKVM - Manual (Page 21)

ASUS ASMB3-IKVM 2-5
2.3 Firmware update
You need to update the ASMB3-IKVM firmware before you start using the
ASMB3-IKVM board.
To update the firmware:
1. Insert the support CD into the optical drive.
2. Restart the remote server, then press during POST to enter the BIOS
setup.
3. Go to Boot menu and set the Boot Device Priority item to [CD-ROM].
4. When finished, press to save your changes and exit the BIOS setup.
5. On reboot, the main menu appears. Select ASMB3-iKVM Firmware Update,
and press to enter the sub-menu.
6. A confirmation message appears, asking whether you want to update the
firmware or not. Press to update.
ASUS Server RS100-E5/PI2 System
FreeDOS command prompt
ASMB3-iKVM Firmware Update
Are you sure you want to update ASMB3-iKVM Firmware now?
Yes or No [YN]?
The firmware updating process starts.
7. When the update process is completed, the following screen appears.
Starting Firmware Upgrade
Uploading Firmware File
0% ------------------- 50% ------------------ 100%
Upload complete.
Flashing Firmware (takes about 1min)
Successfully upgraded firmware.
Press any key to continue ...
8. Turn off the system and unplug the AC power cord for 5 seconds before
restarting the system
You may update firmware from the web-based user interface. Refer to page 3-25
for details.