Asus M2N-VM DVI - Manual (Page 72)

2-26 Chapter 2: BIOS setup
Memory Configuration
Select the DRAM
Frequency programing
method. If Auto,
the DRAM speed will
be based on SPDs.
If Limit, the DRAM
spe will not exceed
the specific value.
If Manual, the DRAM
specified will be
programmed regardless.
Memory Configuration
Memory Setting: 266MHz-4.0-4-4-11-2T
Memclock Mode [Auto]
CAS Latency (CL) [Auto]
TRCD [Auto]
TRP [Auto]
TRAS [Auto]
Command Timing (2T mode) [Auto]
MCT Timing Mode [Auto]
Bank Interleaving [Auto]
Enable Clock to All DIMMS [Disabled]
MemClk Tristate C3/ATLVID [Disabled]
Memory Hole Remapping [Enabled]
Memclock Mode [Auto]
Sets the memory clock mode.
Configuration options: [Auto] [Limit] [Manual]
The following item appears when the Memclock Mode is set to Limit or Manual.
Memclock Value [2�� M�z]
Sets the memory clock mode limit.
Configuration options: [4�� M�z] [533 M�z] [ 667 M�z] [ 8�� M�z]
CAS Latency (CL) [Auto]
Sets the CAS Latency (CL) mode.
Configuration options: [Auto] [3.�] [4.�] [5.�] [6.�]
TRCD [Auto]
Sets the TRCD mode.
Configuration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
TRP [Auto]
Sets the TRP mode.
Configuration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
TRAS [Auto]
Sets the TRAS mode.
Configuration options: [Auto] [5 CLK] [6 CLK] ~ [18 CLK]
E3608_M2N-VM-DVI.indb 15 12/27/07 4:39:53 PM