Asus G-SURF365 - Manual (Page 76)

2-24 Chapter 2: BIOS setup
TRP [Auto]
Sets the TRP mode.
Configuration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
TRAS [Auto]
Sets the TRAS mode.
Configuration options: [Auto] [5 CLK] [6 CLK] ~ [17 CLK] [18 CLK]
TRRD [Auto]
Sets the TRRD mode.
Configuration options: [Auto] [2T] [3T] [4T] [5T]
TRC [Auto]
Sets the TRC mode.
Configuration options: [Auto] [11T] [12T] ~ [25T] [26T]
Bank Interleaving [Disabled]
Allows you to set the bank memory interleaving mode.
Configuration options: [Disabled] [Auto]
Enable Clock to All DIMMs [Disabled
Enable or disable the unused clocks to DIMMs even memory slots are not
populated.
Configuration options: [Disabled] [Enabled]
MemClk Tristate C3/ALTVID [Disabled]
Enable or disable the MemCLK Tri-Stating during C3 and Alt VID.
Configuration options: [Disabled] [Enabled]
Memory Hole Remapping [Enabled]
Enables or disables the memory remapping around memory hole.
Configuration options: [Disabled] [Enabled]
Power Down Control [Auto]
Allows DIMMs to enter power down mode by deasserting the clock enable
signal when DIMMs are not in use.
Configuration options: [Auto] [Disabled]