Iii. hardware setup – Asus P2V-B User Manual

Page 23

ASUS P2V-B User’s Manual

CPU

III. H/W SETUP

III. HARDWARE SETUP

WARNING!

Make sure the heatsink is mounted tightly against the SECC, SECC2

or SEPP; otherwise, the CPU will overheat. You may install an auxiliary fan to
provide adequate circulation across the processor’s passive heatsink.

4. Secure the SECC/SECC2/SEPP

Secure the SECC/SECC2/SEPP in place by pushing the SECC/SECC2/SEPP
until it is firmly seated on the Slot 1 connector.

SECC with Pentium

II only: The SECC locks should be outward when se-

cured so that the lock shows through the retention mechanism’s lock holes.

5. Attach the Thermal Sensor Cable (optional): If you purchased an ASUS Smart

Fan (ASUS S-P2FAN) with an integrated thermal sensor cable (ASUS P2T-Cable)
or purchased separately the P2T-Cable, you can connect the thermal sensor cable to
your motherboard’s thermal sensor connector. (See next page for information on
ASUS Smart Thermal Solutions.)

3. Insert the SECC/SECC2/SEPP

SECC with Pentium

II only: Push the SECC’s two locks inward until you hear

a click (the picture in step 2 shows the locks in the outward position and inward in
the picture below).

With the heatsink facing the motherboard’s chipset, push the SECC, SECC2, or
SEPP gently but firmly into the Slot 1 connector until it is fully inserted.

SECC2/SEPP

Push lock inward

SECC

SECC2/SEPP

CPU fan cable to
fan connector

CPU fan
cable to fan
connector

Lock hole