Asus P2V-B - Manual (Page 13)

ASUS P2V-B User’s Manual 13
III. HARDWARE SETUP
Contents
III. H/W SETUP
Motherboard Settings
1) KBPWR p. 14 Keyboard Power Up
2) VIO p. 15 Voltage Input/Output Selection
3) VCORE p. 15 Voltage Regulator Output Selection
4) FS0, FS1, FS2, FS3 p. 16 CPU BUS Frequency Selection
5) BF0, BF1, BF2, BF3 p. 16 CPU to BUS Frequency Multiple
Expansion Slots/Sockets
1) System Memory p. 18 System Memory (DIMM)
2) DIMM Sockets p. 19 DIMM Memory Installation Procedures
3) Slot 1 p. 21 Central Processing Unit (CPU)
4) SLOT1, SLOT2 p. 26 16-bit ISA Bus Expansion Slots *
5) PCI1, PCI2, PCI3 p. 26 32-bit PCI Bus Expansion Slots
6) AGP p. 27 Accelerated Graphics Port
Hardware Monitor
1) RT2, RT3 p. 25 Thermal Sensor Connectors
Connectors
1) KB-PS2KB p. 28 Keyboard Connector (5-pin female)
2) FLOPPY p. 28 Floppy Disk Drive Connector (34-1 pins)
3) PARALLEL p. 29 Parallel Port Connector (25-pin female)
4) COM1, COM2 p. 29 Serial Ports (9-pin male)
5) PRIMARY/SECONDARY IDE p. 30 Primary / Secondary IDE Connectors (Two 40-1pins)
6) IDELED
p. 30 IDE Activity LED Connector (2 pins)
7) CHA_, CPU_, PWR_FAN p. 31 Chassis, CPU, Power Supply Fan Connectors (Three 3 pins)
8) WOL_CON p. 31 Wake-On-LAN Connector (3 pins)
9) MSG.LED (PANEL) p. 32 Message LED Lead (2 pins)
10) SMI (PANEL) p. 32 System Management Interrupt Lead (2 pins)
11) PWR.SW (PANEL) p. 32 ATX Power/Soft Power Switch Lead (2 pins)
12) RESET (PANEL) p. 32 Reset Switch Lead (2 pins)
13) PWR.LED (PANEL) p. 32 System Power LED Lead (3-1 pins)
14) KEYLOCK (PANEL) p. 32 Keyboard Lock Switch Lead (2 pins)
15) SPEAKER (PANEL) p. 32 System Warning Speaker Connector (4 pins)
16) USB/MIR P. 33 USB, PS/2Mouse, IrDA Module Connector (18-1 pins)
17) IR p. 33 IrDA-Compliant Infrared Module Connector (5 pins)
18) WOR p. 36 Wake-On-Ring Connector (2 pins)
19) CHASIS p. 36 Chassis Intrusion Sensor Lead (4-1 pins)
20) SMB p. 35 SMBus Connector (5-1 pins)
21) ATXPWR p. 34 ATX Power Supply Connector (20 pins)
22) PS/2 p. 34 AT Power Supply Connector (20 pins)
* The onboard hardware monitor uses the address 290H-297H so legacy ISA cards must not
use this address otherwise conflicts will occur.